November 2026
RC Car
A small remote-controlled car I built from September to November 2026. It drives and turns. I designed the chassis and gears in Onshape and laid out the motors and batteries myself.

Challenges
Not written yet.
Skills used
- Onshape
- CAD
- Gear design
- 3D printing
- Soldering
- Wiring
- Bandsaw
Brief
A small RC car built from scratch with no code in it. It can drive and turn. I worked on it from September to November 2026.
What I did
Design. I designed the chassis and the gears in Onshape, then 3D printed the parts. I also planned where the motors, batteries and the rest of the parts sit.
Wiring. Small motors drive the wheels. They are wired to battery cages that hold AA and 9V batteries. A controller talks to a motor controller, and the motor controller runs the motors. I soldered all of it together.
Axle. I cut the metal shaft for the axle to length on a bandsaw.